T NATION | Fix Your Front Squat
by Lee Boyce 6/21/2011 Fix Your Front Squat
When most lifters boast online about their Herculean squat numbers, I'd guess that 80 percent or more are referring to back squats.
It's the most popular squat variation in the world and I'll be the first to give it the credit it deserves but there are times when it might be advantageous to give your traps a break and incorporate front squats.
So why does the front squat so often get thrown under the bus? For one thing, front squats are hard work, something that many commercial gym heroes tend to avoid like egg yolks and body hair. Since moving heavy weight for the cell phone camera is priority number one for your typical egocentric meathead, most stay in their comfort zone and bang out leg presses, leg extensions, and sordid half-rep back squat perversions, complete with more mid-set grunting and groaning than a porn casting.
After all, they reason, what can you get from front squats that you can't get from back squats? Good question.
Why Should I Be Doing Front Squats?
Front squats will do three things if you do them correctly:
* Increase depth achieved
* Improve core strength
* Activate glutes
When a barbell is loaded on the front of the body, the pelvis gets to tilt backwards somewhat, which makes the hamstrings less taut. This gives them the freedom to allow a greater ROM at the bottom of the lift. This pelvic tilt also allows the lower abs to contribute to the lift more, and takes the hip flexors away from "blocking" the movement.
So, just like a goblet squat, you get a hell of a lot lower then you do in a back squat. The torso also gets to stay more upright, which requires the obliques to provide stability.
Finally, due to the tremendous knee extension involved, the front squat is rightly seen as a major quad developer. Since the thighs drop far below parallel to the floor, it's safe to say that hip flexion is greatly increased too, forcing the glutes to assist the concentric half of the lift.
With all of these kick-ass benefits, it seems like a no-brainer that front squats should make a regular appearance in a typical program.
Why You Suck At Front Squats
Other than the obvious (you aren't doing them enough), there are a few things that limit lifters from achieving a decent front squat.
Your Abs Aren't Strong Enough
Front squats require considerable core involvement. You'd do well to incorporate some exercises for anti extension (to prevent overarch) and oblique work so they function well as stabilizers.
Ab wheel rollouts OR Blast Strap fallouts
Suitcase deadlift OR Paloff press
These are a few of what I consider to be staple movements to improve the function of the abdominals and wake them up for the real stuff.
Your Elbows Won't Stay High Enough
The goal should be to keep the elbows pointing as far upwards as possible to promote parallel lines between the upper arm and the floor at all times.
If you've noticed that every time you front squat your elbows start pointing towards the floor after only two reps, causing you to rack the weight prematurely, there's a reason for that.
In this case, the first thing to do would be to activate your rotator cuff. If these small muscles aren't playing their part in externally rotating the upper arm, your elbows will drop faster than Tiger Woods' "Just Do It" promo.
Luckily, there are a couple of things you can do to remedy that problem.
Seated dumbbell external rotation
Be sure to use a light weight. It won't take much!
You Can't Stand Tall
Proper thoracic extension is very important for front squats, as the Turtleback syndrome affects many when they have to bear a front load.
Take a barbell and perform a set of five front squats. Do you notice your mid-back rolling like the Andes? Have someone watch you if you have any doubts.
Either way, there are a few simple fixes.
* PNF intercostal stretch
* Foam roller extensions
* Trap 3 raises
(See this article for examples of all three)
Something to keep in mind though studies have shown that after the sixth rep of a typical set of front squats or front loaded work, the rhomboids begin fatiguing and can no longer hold a constant isometric. For this reason, try to keep sets of front squats towards the lower end of the repetition continuum.
Getting a Grip
Many lifters will use the "California" style or cross-armed grip on the bar to allow it to rest on the shoulders when performing a front squat. Big mistake. Since one elbow stays higher than the other on a cross-armed grip, under substantial load, it can act against proper structural alignment of the shoulders, and has the potential to refer imbalances right through to the hips and knees.
For this reason, I highly recommend using a clean grip, which also has better carryover to proper techniques involved with any Olympic lifts as well as overhead pressing. It may feel uncomfortable at first, but remember to keep a proud chest and get those elbows up!
It's okay to remove a finger or two from under the bar (I like to remove my thumb and pinky finger as it helps take stress off the wrists and allows for the elbows to stay up). Otherwise, make sure the lats, triceps, and forearms get a good stretch before beginning. (See picture below.)
Fix Your Front Squat
Here are some basic tips to look out for when doing front squats.
* Keep the toes pointed slightly outwards, and make sure knees track in the direction the toes point
* Keep the chest up proud
* Elbows high at all times
* Hinge from the hips, and let the glutes fire to come back up
* Press through the full foot, keeping the heel on the ground
* Breathe deep on the eccentric, and hold full of air at the bottom to increase intra-abdominal pressure
* Don't panic the legs have loads of fight or flight in them. You'll get out of the hole!
Lifters Who Should Be All Over Front Squats
Tall Lifters. It's asking a lot of someone who's over six feet to get far below parallel during a back squat. Front loading allows the center of gravity to shift backwards slightly, and unloads the low back and hips enough for them to achieve this depth. Your chicken legs may be due to lack of back squatting depth.
Lifters With Tight Hamstrings. As noted, a front load will make the hamstrings less taut, and therefore promote more range of motion during the negative phase of the squat.
Getting Out of The "Embarrassing" Category
If these pointers alone don't substantially improve your front squat, I've put together a cool quasi-workout that serves as a good tool to bring up your fronts.
Think of this as a "front squat conditioning" workout. The goal is to get the abs firing correctly, get the upper back tight, and start practicing the movement properly and under decent load.
Begin by foam rolling and static stretching hip flexors, hamstrings, glutes, and lats.
Perform the following workout as a sequence. Rest 90 seconds between each exercise.
Front squat workout
Exercise Reps % 1RM
A Front squat 6 70%
B Ab wheel rollout 12
Foam roller extensions *
C Front squat 5 80%
D Stomach-up pull-ups 6-8
E Front squat 4 80%
F Trap-3 raises 12 per arm
PNF intercostal stretch
G Front squat 4 80%
H DB external rotations 12 per arm
I Front squat 4 80%
* as many as needed
see video below be sure not to allow the feet to do anything but hang straight down to get full stimulation of the abdominals. It should look like you're trying to pull yourself to horizontal.
at a 3010 tempo
This mini-workout will take 20 minutes to get through. You'll notice reps are kept low, as are intensities. The reason for this is the abdominals and upper back muscles are being hit with direct exercises to mildly fatigue them between each set of front squats. Loading aggressively could be inviting injury. An elevated heart rate thanks to the 90-second rest interval will allow practicing keeping the elbows high and chest up while slightly fatigued.
There's nothing fancy-shmancy about this workout, and it doesn't even need to replace a real leg workout. Chances are you won't be too sore the next day, either. This workout can find its home on a supplementary day for a few weeks.
Squatting to Oblivion!
Adding load to the body effectively trains muscle, of course. Contrary to popular belief, though, the answer isn't always throwing on heavier and heavier weight. You'd be surprised how added ROM, improved technique, or a bit of both can be game-changers for tapping into sleepy motor units or just plain increasing difficulty.
Moreover, they just may be the missing link to make you the guy whose chicken legs flew the coop.
Views 497 Comments 4
|06-23-2011, 09:22 AM||#2|
is loving life.
|06-23-2011, 10:24 AM||#3|
With apelike velocity
Join Date: May 2010
Training Exp: 2 years
Training Type: Heavy Duty
Fav Exercise: Deadlift
Fav Supp: Steak
Just read this after front squatting yesterday. haha
Pretty good article. Only disagreement would be with the cross-arm grip...I like it better than an Oly one.
Form follows function.
|06-23-2011, 10:35 AM||#4|
aka Gimpy the 8th dwarf
SFHW = Win
Tournaments Won: 1
Join Date: Apr 2011
Location: Near Dallas, TX
Training Exp: 1-2
Training Type: General Fitness
Fav Exercise: Kettlebells, for now
Fav Supp: XTend
Agreed. I definitely need to work on shoulder/tricep/wrist flexibility to get a proper clean grip. I've always wimped out with a cross-arm grip and as a result the weights quickly rolled down my arms after rep 2 or so.
"Generally people can't squat because they're lacking in the 'lower ab' area. As in they need to grow a set." - LtL
"No one ever got big or strong by lifting lightweights" - Carl1174
Follow my log here: Aurik's Back to Basics log
Valentin Konstantin Platz
|06-23-2011, 10:51 AM||#5|
is after a Masters WR
Bearded Beast of Duloc
I can't physically do the Olympic grip so it's an easy choice for me.
|fix, front, squat|
|Another 400lb front squat||Tannhauser||Powerlifting & Strength Training||14||03-29-2012 12:27 PM|
|Road to the 400lbs + Front Squat||Bodybygamma||Powerlifting & Strength Training||13||03-06-2012 08:07 AM|
|Impressive front squat||Tannhauser||Powerlifting & Strength Training||4||10-19-2011 03:46 PM|
|Front Squat||Gaz6682||General Board||6||09-27-2011 09:46 AM|
|Platform: The Front Squat||BendtheBar||Video Compilations||0||05-10-2011 04:50 PM|
|Article Tools||Search this Article|