|04-02-2013, 08:08 PM||#1|
Join Date: May 2011
Location: Ft. Hood, Tx
Training Exp: On and off for 17 years.
Training Type: ARGH!!!
Fav Exercise: Bosu kickback pistols
Fav Supp: Crack on a trisket
First time in a bench shirt
...and possibly my last for a little while.
My used Titan Super Katana, size 46, arrived today. My first reaction, and the feeling I still have, is that the material doesn't "stretch" at all! Honestly, it might as well be made of steel.
Here's what I did before I shirted up-
At this point I put on the shirt. I used shirt slippers and I WAS able to get the end of the sleeves past my elbows, but just inside the edge of the sleeve was slightly wrinkled, and no matter what I did I couldn't get the sleeves to move up any more. I knew that they weren't even close to seating properly in my armpits, but I continued with putting it on.
Eventually I got it all the way over myself, and got my new lever belt on as well.
I put 375 on the bar and attempted to get into position, but I couldn't get my hands out to grip the bar without shooting my shoulders forward. The bar was too low. I adjusted my rack up an inch and got into position again.
This time I was able to unrack the bar and hold it over myself. The 375 might as well have been 135 as I held it. I tried to lower the bar and exactly what I thought would happen, did. It moved about 1 inch downward. That's it. 1 inch, then it stopped and I pushed it back up, then racked it. I laid on the bench for a few seconds because I was seeing stars, and I realized that the shirt had been choking me when I "lifted".
I pulled the shirt down a little under my belt, then collected myself before getting back into position to try again. I just kept thinking "Tuck your elbows, tuck your elbows and let the weight come down." I unracked the bar, then tucked my elbows as hard as I could. My elbows actually went over my stomach I tucked so hard.
The result? The bar came down 2 inches, at the most, before shooting back up.
But no stars this time, and I did get the bar to move twice as far, after all.
I know that it takes a lot of work to get a touch in a shirt, and I know that I was never going to even come close to touching 375, but I didn't try to add weight because I know that main problem; the shirt is just too tight. The arms should be seated higher. I can tell just by watching videos on youtube that this shirt doesn't fit as it should.
But, there's good news. I was already planning to lose weight. I'm currently in the high 230's, and I want to get down to the low 220's. Hopefully this will make the shirt fit better. I'll continue to try on the shirt every few weeks as I lose weight and see if it makes a difference in the fit. If once I reach the low 220's I still can't get it to seat correctly then I'll sell it and get a 48.
I'm also going to hold off on getting a squat suit until I can either make this shirt work or get one that does.
Current PRs at 242, raw w/ wraps- 525, 355, 605, 1485
Roboro tui, perimo vester adversarius
(Build yourself, destroy your enemy)
|Thread||Thread Starter||Forum||Replies||Last Post|
|Getting the most out of a bench shirt||J_Byrd||Powerlifting & Strength Training||1||09-18-2012 11:39 AM|
|How to measure for a bench shirt||RobMoriRB||Powerlifting & Strength Training||4||08-31-2012 10:36 AM|
|Putting on bench shirt||LtL||Powerlifting & Strength Training||7||01-07-2012 01:16 PM|
|How to Put on A Bench Shirt||BendtheBar||Video Compilations||0||12-19-2011 08:56 AM|
|Epic Meal Time t-shirt||BendtheBar||General Board||6||06-14-2011 09:56 AM|